Manager Privileges - HP PROCURVE 6120 Management And Configuration Manual

Manager Privileges

Manager privileges give you three additional levels of access: Manager, Global
Configuration, and Context Configuration. A "#" character delimits any Man-
ager prompt. For example:
ProCurve#_ Example of the Manager prompt.
■ Manager level: Provides all Operator level privileges plus the ability to
perform system-level actions that do not require saving changes to the
system configuration file. The prompt for the Manager level contains only
the system name and the "#" delimiter, as shown above. To select this
level, enter the enable command at the Operator prompt and enter the
Manager password, when prompted. For example:
ProCurve> enable
Password:
ProCurve# _
■ Global Configuration level: Provides all Operator and Manager level
privileges, and enables you to make configuration changes to any of the
switch's software features. The prompt for the Global Configuration level
includes the system name and "(config)". To select this level, enter the
config command at the Manager prompt. For example:
ProCurve# config
ProCurve(config)#_ The Global Config prompt.
Context Configuration level: Provides all Operator and Manager priv-
■
ileges, and enables you to make configuration changes in a specific
context, such as one or more ports or a VLAN. The prompt for the Context
Configuration level includes the system name and the selected context.
For example:
ProCurve(eth-1)#
ProCurve(vlan-10)#
The Context level is useful, for example, for executing several commands
directed at the same port or VLAN, or if you want to shorten the command
strings for a specific context area. To select this level, enter the specific
context at the Global Configuration level prompt. For example, to select
the context level for an existing VLAN with the VLAN ID of 10, you would
enter the following command and see the indicated result:
ProCurve(config)# vlan 10
ProCurve(vlan-10)#
Using the Command Line Interface (CLI)
Enter enable at the Operator prompt.
CLI prompt for the Manager password.
The Manager prompt appears after the
correct Manager password is entered.
Enter config at the Manager prompt.
Using the CLI
4-5