Oobm And Switch Applications - HP PROCURVE 6120 Management And Configuration Manual

Network Out-of-Band Management (OOBM)
Concepts
G-6

OOBM and Switch Applications

The table below shows the switch applications that are supported on the
OOBM interface as well as on the data interfaces. In this list, some applications
are client-only, some are server-only, and some are both.
Application Inbound OOBM
(server)
Telnet yes
SSH yes
SNMP yes
TFTP yes
HTTP yes
SNTP n/a
TIMEP n/a
RADIUS n/a
TACACS n/a
DNS** n/a
Syslog n/a
Ping yes***
Traceroute yes***
n/a = not applicable
* = SNMP client refers to SNMP traps as they originate from the switch.
** = DNS has a limit of two servers — primary and secondary. Either can be configured to
use the OOBM interface.
*** = Ping and Traceroute do not have explicit servers. Ping and Traceroute responses are
sent by the host stack.
For applications that have servers,
listen mode. There is now a
selection of those options. Default value is
cation Server Commands (page G-13) in the "Tasks" section below for details
of the new command syntax.
Outbound OOBM Inbound Data
(client) Plane (server)
yes
n/a
yes*
yes
n/a
yes
yes
yes
yes
yes
yes
yes
yes
options have been added to
oobm/data/both
listen keyword in the CLI commands to allow
both for all servers. See the Appli-
Outbound Data
Plane (client)
yes yes
yes n/a
yes yes
yes yes
yes n/a
n/a yes
n/a yes
n/a yes
n/a yes
n/a yes
n/a yes
yes*** yes
yes*** yes