Link Aggregation Control Protocol Configuration; Lacp Port Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Hp 10gb ethernet bl-c switch iscli reference guide
Hide thumbs Also See for 445860-B21 - 10Gb Ethernet BL-c Switch:
Table of Contents

Advertisement

Link Aggregation Control Protocol configuration

The following table describes the LACP Configuration commands.
LACP Configuration commands
Table 115
Command
lacp system-priority
{<1-65535>}
lacp timeout
{short|long}
show lacp

LACP Port configuration

The following table describes the LACP Port Configuration commands.
LACP Port Configuration commands
Table 116
Command
lacp mode
{off|active|passive}
lacp priority {<1-65535>}
lacp key {<1-65535>}
show interface port
{<port number>} lacp
Description
Defines the priority value (1 through 65535) for the switch. Lower numbers provide
higher priority. The default value is 32768.
Command mode: Global configuration
Defines the timeout period before invalidating LACP data from a remote partner.
Choose short (3 seconds) or long (90 seconds). The default value is long.
HP recommends that you use a timeout value of long, to reduce LACPDU
NOTE:
processing. If your switch's CPU utilization rate remains at 100% for periods of 90
seconds or more, consider using static trunks instead of LACP.
Command mode: Global configuration
Display current LACP configuration.
Command mode: All
Description
Set the LACP mode for this port, as follows:
off—Turn LACP off for this port. You can use this port to manually
configure a static trunk. The default value is off.
active—Turn LACP on and set this port to active. Active ports initiate
LACPDUs.
passive—Turn LACP on and set this port to passive. Passive ports do not
initiate LACPDUs, but respond to LACPDUs from active ports.
Command mode: Global configuration
Sets the priority value for the selected port. Lower numbers provide higher
priority. Default is 128.
Command mode: Global configuration
Set the admin key for this port. Only ports with the same admin key and oper
key (operational state generated internally) can form a LACP trunk group.
Command mode: Global configuration
Displays the current LACP configuration for this port.
Command mode: All
Configuration Commands
140

Advertisement

Table of Contents
loading

Table of Contents