Replacing The Skimmer Rollers; Figure 1.34: Positioning And Inserting The Skimmer Flag - Bell and Howell Spectrum XF Maintenance Manual

11. Lower the retention lever. Make sure that when the skimmer assembly is raised and
lowered manually, that the flag raises and lowers with it.
12. Lower the auto/manual feed lever located to the left of the ADF to the 'A' position.
13. Close the scanner transport cover.
14. Power on the scanner.
15. Boot up the host PC.
16. Clean the skimmer rollers (refer to section
instructions).
Note
If the skimmer housing is damaged, replace the entire skimmer assembly and
skimmer flag (refer to
instructions).
Note
The procedure for replacing the front and rear skimmer assembly rollers is the
same.
To replace the skimmer rollers, perform the following:
1. Remove the skimmer assembly (refer to section
Skimmer Assembly
2. To remove the top cover of the skimmer assembly, squeeze the tabs located on top
of the assembly together and pull the cover off the assembly.
S006504 Rev D

Figure 1.34: Positioning and Inserting the Skimmer Flag

1.4.11
1.4.10 Removing and Replacing Skimmer Assembly
for instructions).
1 Operator Maintenance
1.4.5 Cleaning the Skimmer Rollers

Replacing the Skimmer Rollers

1.4.10 Removing and Replacing the
for
for
23 of 27