Cleaning The Feeder Skimmer Rollers; Figure 31. Spraying The Skimmer - Bell and Howell Copiscan 8000 Spectrum Operator's Manual

This menu is used to prepare the scanner to receive new control firmware, which is
downloaded using special software for the PC and a standard serial cable. In the unlikely
event that you must download new control firmware, Böwe Bell + Howell Technical
Support will contact you with instructions.
NOTE:
If the Download New Software? menu is started mistakenly and no actual download
has begun, it is safe to cycle scanner power. The scanner will power up normally.
6.7

Cleaning the Feeder Skimmer Rollers

As the skimmer rollers become dirty, they may begin to slip on the paper or cause multi-
feeds. To prevent feeding problems, clean the skimmer rollers once a day or as needed.
NOTE:
Types and condition of the documents being scanned may require more frequent
cleanings.
Take the following steps to clean the skimmer rollers:
1. Remove all documents from the feeder and exit tray.
2. Using the front panel buttons, press the CLEAR button to put the scanner in READY
mode.
3. Press the CLEANING MENU key on the front panel.
4. Press the F1 key to start the scanner.
5. Using the rubber tire cleaner, spray the center leading edge of one skimmer cleaning
sheet.
Figure 31. Spraying the Skimmer Cleaning Sheet
www.bbhscanners.com
1-800-SCAN-494 Sales
1-800-SCAN-495 Technical Support
Copiscan 8000 Spectrum Operator Manual
61