General Maintenance - Bell and Howell Spectrum XF Maintenance Manual

Scanner

Hide thumbs

Table Of Contents

Table of Contents

3. Press the F3 key [NEXT] to view the scanner firmware revision number.

4. Press the F3 key [NEXT] to view the feeder revision number.

5. Press the F3 key [NEXT] to view the front IJPM (imprinter) revision number (where

applicable).

6. Press the F3 key [NEXT] to view the back IJPM (imprinter) revision number (where

applicable).

7. Press the F3 key [NEXT] to view the page entry sensor revision number.

8. Press the F3 key [NEXT] to view the page exit sensor revision number.

9. Press the F3 key [NEXT] to view the operator interface revision number.

10. Press the F3 key [NEXT] to view the EGSA software revision number.

11. Press the F3 key [NEXT] to view the EGSA hardware revision number.

12. Press the F3 key [NEXT] to view the EGSA FPGA revision number.

13. Press the F3 key [NEXT] to view the EGSA CPLD revision number.

14. Press the F3 key [NEXT] to view the EGSA CCD IF revision number.

15. Press the F3 key [NEXT] to view the EGSA camera LCA revision number.

16. Press the F3 key [NEXT] to view the MBX revision number.

This section details scanner maintenance tasks that must be performed on a daily,

weekly, monthly, or yearly basis to achieve optimum performance from your scanner.

Below is a typical maintenance schedule for your scanner. Individual maintenance

schedules may vary somewhat depending on the documents that are being scanned and

the environment the scanner is operated in.

Activity

Clean back

camera's glass

cover

Clean glass flat

S006504 Rev D

1.4

# Hours of Operation

Biweekly or as needed.

If the glass flat is being

cleaned due to

degradation in image

quality, the glass cover

should be cleaned as

well.

Once per day, or as

needed.

1 Operator Maintenance