Spectrum XF Maintenance Manual
3. Push down on the right side of the glass flat and slide it to the right until you see the
edge of the glass flat on the left side. The glass flat will slightly lift away from the
metal tray for you to grasp.
4. Holding the left side, gently pull the glass flat towards the left, taking care not to twist
or leverage the tip where it still touches the scanner.
5. Check the glass flat for chips and scratches.
Note
If the glass flat is chipped or scratched, replacement flats are available for
purchase individually and as part of the Spectrum XF All-In-One Kit through
Böwe Bell + Howell Authorized Service Providers (ASPs), Authorized Spare
Parts Resellers (ASPRs) and at www.bbhscanners.com. A complete listing of
ASPs and ASPRs can also be found there.
Cleaning Both Sides of the Glass Flat
To clean both sides of the glass flat, follow the procedure below:
1. Remove the glass flat from the scanner (refer to section
Flat).
2. Using the Glass & Roller Cleaner along with the Glass Cleaning Cloth, carefully
clean the front and back surfaces of the glass. Inspect the glass flat after cleaning to
ensure all dust and residue has been removed.
Note
Glass flats that are brand new should also be cleaned on both sides before
installation.
3. Place the cleaned glass flat back into the scanner (refer to section
the Glass
Flat).
6 of 27
Figure 1.10: Lifting the Glass Flat Out
1.4.1.1 Removing the Glass
1.4.1.2 Replacing
S006504 Rev D