Spectrum XF Maintenance Manual
4. Open the side access panel of the scanner by pulling it away from the scanner, to
the left. The operator-accessible areas of the scanner are now exposed.
5.
Remove the front-page lamp housing by grasping black handle and gently
toward you
(Figure
6.
Gently pull each lamp out
7. Insert new
la
mps
back in to the housing.
8. Slide the lamp housing back in to the side
9. Repeat steps 5 through 8 for the back-page lamps.
10. Close the side access panel.
11. Close the scanner transport co
12. Power on the scanner.
13. From the Home menu, p
Replacement menu.
14. If you repla ed the
c
press the F1 key [FRONT]. If you only replaced the back-page lamps, skip ahead
step 17 of this procedure.
15.
Press the F1 key [YES]. A
several seconds, followed by the "Front Lamps Reset" confirmation message.
16.
Press the F1 key [CONTINUE].
17. If you replaced the back lamps, p
18. Press the F1 key [YES]. A "Calibrate Back Camera" message will be dis
several seconds, followed by the "Back Lamps Reset" confirmation message.
20 of 27
1.29).
of its housing.
Figure 1.30: Removing the Lamps from the Housing
ver.
ress the LEFT ARROW key until you reach the Lamp
Lamp Replacement
FRONT BACK
Figure 1.31: Lamp Replacement Menu
front lamps only or both the front-page an
"Calibrate Front Camera" message will be displayed for
ress the F2 key [BACK]
Back lamps replaced?
YES
CANCEL
Figure 1.32: Back Lamps Replaced Confirmation
frame of the scanner until it stops.
d back-page lamps,
(Figure 1.31
pull it
to
).
played for
S006504 Rev D