Figure 1.35: Removing The Skimmer Assembly's Cover; Figure 1.36: Lifting Out The Rollers; Figure 1.37: Removing The Roller - Bell and Howell Spectrum XF Maintenance Manual

Spectrum XF Maintenance Manual

Figure 1.35: Removing the Skimmer Assembly's Cover

3. Lift the rollers up and out of the skimmer assembly.
4. Pull the roller shaft from the roller assembly. It should slide out easily. Discard old
rollers.
5. Place the new roller on the roller shaft so that the larger opening faces the gear.
6. Place the roller assemblies back in to the lower housing.
7. Snap the top housing cover back onto the lower housing.
24 of 27

Figure 1.36: Lifting Out the Rollers

Figure 1.37: Removing the Roller

S006504 Rev D