Figure 1.14: Inserting The Tech Wipe - Bell and Howell Spectrum XF Maintenance Manual

Figure 1.14: Inserting the Tech Wipe

Note
Tech Wipes are part of the Spectrum XF All-In-One Maintenance Kit. Refer to
1.5 Ordering XF All-In-One Consumables and Maintenance Kits
for information on whom and where they can be purchased from. Tech Wipes
can also be purchased independent of the Spectrum XF All-In-One
Maintenance Kit.
6. Lay the foam end of the Tech Wipe flat side down on top of the glass cover and
gently wipe any dust particles from its surface, making sure to cover the entire length
of the glass.
Note
For best results, do not re-use Tech Wipes. Doing so may re-introduce dust
from previous cleanings.
Note
For best results, Tech Wipes should not be sprayed with any type of cleaner
except in the event of a liquid spill. If a liquid spill should occur, use the
appropriate Glass & Roller Cleaner (S005659) recommended by Böwe Bell +
Howell.
Note
For the purpose of this procedure
scanner with the back scanner cover removed in order to better illustrate how
the glass cover should be cleaned using the Tech Wipe. This is for illustration
purposes only! The proper cleaning procedure for the glass cover does not
include removing the back scanner cover.
S006504 Rev D
1 Operator Maintenance
Figure 1.15 was taken from the back of the
in this manual
9 of 27