Replacing The Lamps; Figure 1.29: Pulling The Lamp Housing Out - Bell and Howell Spectrum XF Maintenance Manual

Warning
T he lamps may be very HOT. Use precaution when changing the bulbs.
5. Remo ve the front-page lamp housing by grasping the black handle and gently pu
it out, away from the scanner (to the left).
6. Pull each lamp out of the housing carefully.
7. After the lamps ar
free of dust.
8. Insert both lamps back into the housing.
9. Slide the lamp housing back in to the side
10. Repeat steps 4 through 7 to remove and clean the back-page lamps.
Note
If after cleaning, the lamps do not operate or the light source is still degraded,
re-che ck the position of the lamps and housing(s). Improperly installed lamps
are a common source of these conditions. Replace lamps in pairs if
necessary.
11. Close the side access panel.
12. Close the scanner transport co
13. Power up the scanner.
14. Boot up the host PC.

Replacing the Lamps

To replace the lamps, follow the procedure below:
1. Shut down the host PC.
2. Power off the scanner.
3. Open the scanner transp
S006504 Rev D

Figure 1.29: Pulling the Lamp Housing Out

e cool, use an optic cleaning pad to wipe the lam
ver.
ort cover.
1 Operator Maintenance
frame of the scanner until it stops.
lling
ps until they are
19 of 27