Spectrum XF Maintenance Manual
To clean the glass cover, perform the following:
1. Power off the scanner.
2. Lift the scanner transport cover as high as it will rise.
3. Open the scanner's side access panel.
Warning
The lamp assembly may be hot! After the scanner has been powered off,
make sure to let it sit for five to ten minutes to ensure the lamps have cooled
down.
4. Remove the bottom lamp assembly by pulling it out of the scanner, towards you and
set aside.
5. Insert the Tech Wipe into the scanner where the lamp assembly usually resides.
8 of 27
Figure 1.12: Opening the Side Access Panel
Figure 1.13: Removing the Lamp Assembly
S006504 Rev D