Table of Contents
Advertisement
Spectrum XF Maintenance Manual
Note
When the side access panel is opened, a safety interlock removes power from
the tra
nsport motor.
Warning
The lamps may be very HOT. Use precaution when changing the bulbs.
The scanner
lamps should be cleaned monthly (or as needed), and periodically may
need to be replaced. Lamp replacement may be required if the control panel LCD
displays one of the following messages:
- "Check front lamps"
- "Low front lamp level"
Lamps
themselves are available
Kit through Böwe Bell + Howell Authorized Service Providers (ASPs), Authorized Spare
Parts Resellers (ASPRs) and at www.bbhscanners.com. For a complete listing of ASPs
and ASPRs, please visit our website at www.bbhscanners.com.
The simplex scanner has two, individual lamps, and the duplex scanner has two pairs of
individual lamps (front and back) —one pair per camera. All lamps can be replaced
through the side access panel while the scanner transport cover is open.
Not
e
With duplex scanners, both the front and back lamps should be replaced at
the sa
me time for the best reliability and image quality.
C
leaning the Lamps
To clean the lamps, fo
1. Shut down the host PC.
2. Power off the scanner.
3. Open the scanner transp
4. Open the side access panel of the s
the left, as you would open the cove
scanner are now exposed.
18 of 27
1.4.9
- "Check back lamps"
- "Low back lamp level"
for purchas
e and as part of the Spec
llow the procedure below:
ort cover.
canner by pulling it away from the scanner, to
r of a book. The operator-accessible areas of the
Cleaning and Replacing the
trum XF All-In-One
Lamps
S006504 Rev D
Advertisement
Table of Contents
