Figure 1.23: Holding The Cleaning Sheet Under The Skimmer Rollers - Bell and Howell Spectrum XF Maintenance Manual

Spectrum XF Maintenance Manual
5. Using the rubber tire cleaner, spray the center leading edge of one skimmer cleaning
sheet.
6. Place the skimmer cleaning sheet in the ADF, holding the back of the page with one
hand so that the skimmer cleaning sheet does not feed into the transport.
7. Lower the skimmer.
8. While holding the sheet, let the skimmer rollers spin on the area of the sheet that has
been sprayed with rubber tire cleaner. The skimmer wheels should spin freely on the
paper.
9. Slowly let the scanner pull the sheet into the scanner. Release the sheet, allowing
the scanner to pull the sheet all the way through the transport and deposit it in the
exit tray.
10. Remove the skimmer cleaning sheet from the exit tray.
11. Repeat step 8 through 10 two or three times;
Caution
The rubber tire cleaner that is used for the skimmer rollers during cleaning can
drip down on the separator roller during the cleaning process. The rubber tire
cleaner contains an ingredient that can damage the separator roller if it is
exposed to it over time. Therefore, the separator roller should also be cleaned
after the skimmer rollers to avoid damage and the need for replacement (see
1.4.13 Cleaning the Separator
12. Press the STOP key, and then the CLEAR key.
13. Discard the used skimmer cleaning sheet.
14. Clean the separator roller (see
14 of 27
Figure 1.23: Holding the Cleaning Sheet under the Skimmer
Rollers
Roller).
1.4.13 Cleaning the Separator Roller)
S006504 Rev D