Table of Contents
Advertisement
19. Press the F1 key [
20. Press the CLEAR key to return to
21. Boot up the host PC.
Note
After lamp replacement, the camera calibration (
the ne
ed to recalibrate the camera to the new lamp levels (refer to
Calibrating the Cameras
replacement, calibrate the cameras immediately (ignoring the 40 minute
warm-up period), and then re-calibrate after the 40 minute warm-up pe
has occurred.
The skimmer assembly is comprised of two rollers housed in a molded body. Even
though the rollers last up to 600,000 scans each, they will wear out over time, which may
result in document slippage or multifeeding. Therefore, the rollers are considered a
consumable item and are available for purchase individually and as part of the Spectrum
XFAll-In-One Kit. Skimmer housings are also available should they crack or break.
New skimmer assemblies, rollers, Spectrum XF All-In-One Kits, and skimmer housin
are all available through Böwe Bell + Howell Authorized Service Providers (ASPs),
Authorized Spare Parts Resellers (ASPRs) and at www.bbhscanners.com. For a
complete listing of ASPs and ASPRs, please visit our website at www.bbhscanners.com.
Removing the Skimmer Assembly
To remove the skimmer assembly, take the following step
1. Shut down the host PC.
2. Power off the scanner.
3. Raise the auto/manual f
4. Open the scanner transport cover.
Optional: Raise the skimmer flag re
5.
Using your left hand, pull the spring-loaded, green lever toward the left. Secure i
behind the lock pin.
6. Slide the skimmer assembly to the left until it is loose.
S006504 Rev D
CONTINUE].
the Home menu.
for instructions). For be
1.4.10
eed lever located to the left of the ADF to the 'M' position.
tention lever and remove the skimmer flag.
1 Operator Maintenance
) icon will flash, indicating
st
results, after lamp
Removing and Replacing the
Skimmer Assembly
s:
1.4.3
riod
gs
t
21 of 27
Advertisement
Table of Contents
