Configure The Test Set To Emulate A Base Station - HP 83206A User Manual

Chapter 3, Processing Calls

Configure the Test Set to Emulate a Base Station

Configure the Test Set to Emulate a Base Station
PCS OPERATION
SAVING YOUR TEST
SYSTEM
CONFIGURATION
64
S:\HP83206A\USRGUIDE\MANUAL\cpmeas.fm
Before you can use the Test Set to perform call processing tasks, it must be
configured to emulate the base station.
Use the following procedures to prepare the Cellular Adapter to emulate a base
station.
How to emulate a base station
A Access the DCCH CALL CONTROL screen. See
CALL CONTROL screen" on page 65
B Set up the basic channel parameters. See
CALL CONTROL screen:" on page 65
C Define the type of mobile you are testing (PCS or cellular) and compensate for temper-
ature variation if a PCS Interface is present. See
the CAll CONFIGURE II screen:" on page 66
D Put the Test Set in Active state to emulate a base station. See
Active state to emulate a base station" on page 67
Once you have the Test Set configured, you are ready to perform call processing tasks
such as origination, registration, and so on.
If you are using the PCS Interface, be sure to turn on the interface before turning on the Test
Set. Also, set the PCS Mode field on the CONFIGURE screen to On before accessing the
CALL CONTROL screen to test a mobile.
After configuring the Test System to meet your test needs, you can save the configura-
tion for later use in a SAVE/RECALL register. This eliminates the need to manually
reconfigure the Test System each time you use it.
There are two ways to save your test configuration:
1) Press SHIFT, RECALL (SAVE), and enter a name (such as DCCH_PCS). The next
time you turn the Test System on, you can press RECALL and select the name you
entered. The Test System returns to the same state it was at when you saved the set-
tings.
2) Press SHIFT, RECALL (SAVE), and enter the name "POWERON". The next time
you turn the Test System on, the Test System will automatically re-establish all set-
tings you saved.
"A. How to access the DCCH
"B. Make the following settings on the
"C. Make the following settings on
"D. Put the Test Set in