Get Ready To Test - HP 83206A User Manual

Get ready to test

Described In this
Refer to the following flowchart to see the steps necessary to get the Test System
Chapter
ready to test a mobile.
Make sure the Cellular Adapter, and PCS Interface (if used), and the Test Set are properly connected. If the PCS
Interface is used, the HP 83236B System Connectivity test must be successfully completed before proceeding.
Turn on the PCS Interface (if used), then turn on the Test Set. See
"important: turning on the pcs interface" on page 43
Select DCCH to activate
the TIA/EIA-136 screens.
Test
Set has
Option 006?
No
Select CALL CNTL to return to
the primary call processing screen.
Connect the mobile to the Test Set.
Audio
YES
Testing?
NO
Select CALL CNTL from the
To Screen to go to the call
processing screen.
Using
No
PCS
Interface?
Select CALL CNFG to display
Yes
the screen with the Power Meter
Select ZERO to zero the Average
Power measurement.
Chapter 1, Getting Started
.
Set the Notch Filter to track
the audio frequency
generator (AFGen1).
Yes
Perform the PCS Interface preparation
"Using the PCS
steps described in
Interface" on page 44
Zero command.
Get ready to test
.
33