Chapter 7, Screen and Field Descriptions
Parameters of the CALL CONTROL Screen
Amplitude
Band
CC Order
Chan
Connect
210
S:\HP83206A\USRGUIDE\MANUAL\ref.fm
Settings: -137.0 through +18.0
Units: dBm.
The amplitude of the RF signal that the Test Set will transmit.
Note that the available setting is greater than both the specified maximum output
power of the Test System and the system specification as well. This is done to
allow you to use the maximum output power of each individual Test Set.
Settings: Cellular or US PCS
Units: None
The channel band assignment of the traffic channel.
Settings: SSD Upd, Uniq Ch, Send MWI, Send SMS
Units: None
This field is only displayed when Authentication is turned on, and with the mobile
not in the connect state. It allows you to send a shared secret data update, unique
challenge, message waiting indicator, or short message services command to the
mobile.
See also, "Which Control Order Command Should I Use?" in the HP 8920B
Option 801 Condensed Programming Reference.
Settings: 1through 799, 990 through 1023 (Cellular); 1 through 1999 (US PCS)
Units: None, Integer values.
The channel number of the voice or traffic channel.
Settings: On or Off
Units: None.
Connect is an annunciator. It indicates that the Test Set and the mobile are in
Connect state (a call is up).