HP 83206A User Manual page 288

Chapter 11, Installing the Cellular Adapter
PCS Interface Connections
PCS Interface Connections
Ä
Ä
DUPLEX OUT
To DUPLEX OUT
Figure 79
288
S:\HP83206A\USRGUIDE\MANUAL\adptinst.fm
The PCS Interface is used with the Cellular Adapter and Test Set to test US PCS
mobiles (1700 MHz to 1900 MHz). You can also test cellular band (850 MHz)
mobiles through the interface. The interface is controlled entirely through a serial
cable connection to the Test Set.
The PCS Interface is shipped with all cables needed to connect it to the Test Set.
Also shipped with the interface is a memory card containing a System
Connectivity program to verify all connections. This software should be loaded
and run before using the interface.
The following diagrams are for reference only, and do not show all of the rear-
panel connections between the Test Set and the Cellular Adapter (see
page 286). Complete instructions for connecting the PCS Interface to the Test Set
and running the System Connectivity software are included in the PCS Interface's
Operating Manual (HP P/N 83236-90100).
ANT IN
To ANT IN
PCS Interface Connections
10 MHz REF
OUTPUT
REF IN
1 0
A0 (LSB)
.
.
.
A5 (MSB)
HP-IB/Ser
The HP-IB/Ser switch must be set to Ser.
Figure 78 on
REF IN
BNC Tee
Serial Port Connections