Analog Parameters - HP 83206A User Manual

Analog Parameters

Analog parameters are measured in either Connect state or test mode.The
measurement procedure described below is for the Connect mode. To measure in
the test mode, select the
You can measure parameters of a TIA/EIA-136 mobile on its Analog Voice
Channel (AVC). For measurements on this analog channel, use the following
procedure.
The Test Set must be active on an AVC. If your mobile is active on a DTC, you
must first either Originate, Page, or Handoff to an AVC.
1. Make sure the Test Set is in Connect state on an AVC. See
2. Select Meas from the Data/Meas field.
3. The analog measurements should be displayed.
Figure 36 Analog Measurements Display
Chapter 4, Making Measurements
screen.
ANLG MEAS
Analog Parameters
"Registration" on page 93
Scrn27.tif
.
113