Chapter 4, Making Measurements
Droop
Droop
Figure 39
120
S:\HP83206A\USRGUIDE\MANUAL\meas.fm
Droop is measured in either Connect state or test mode.The measurement
procedure described below is for the Connect state. To measure in the test mode,
see
"Test mode measurement procedure" on page
Droop measures the difference between the level of the first symbol and the level
of the last symbol captured by the analyzer.
Droop measurement procedure
1. Make sure the Test Set is in Connect state. See
2. Select Meas from the Data/Meas field.
3. Select one of the two measurement fields that can be modified.
4. Select Droop from the list of choices. The droop measurement will be displayed.
Droop Display
118.
"Registration" on page 93
Con-00dp.tif
.