Front Panel - Classe Audio CP-800 Owner's Manual

10
1 2 3
MENU
CP-800

Front Panel

The front panel of the CP-800 is shown above. The numbers in the drawing
refer to the descriptions that follow.
1 Standby/On Button and Status Indicator LED
Pressing the Standby button puts the CP-800 into standby mode – a
low-power state which leaves the preamp/processor and outputs inactive
but still allows the unit to respond to system commands via any of the
supported control protocols (IR input, LAN, CAN-Bus or RS-232).
If the unit is already in Standby mode, pressing the Standby button fully
powers up the unit.
• LED On (Red) – the CP-800 is in Standby mode.
• LED turns cyan, then green, then off – the CP-800 is in the
process of power-up initialization.
• LED On (Blue), indicates the unit is in the operate mode.
• LED Off – the CP-800 is not getting AC power.
2 Menu On/Off Button
Press once to call up the main page of the menu system, which replaces
the normal front page or Home page of the Touchscreen. Press the Menu
button again to revert to the Home page.
The menu system gives you control over operational details including:
system setup options, various display options and custom installation
capabilities so that the CP-800 integrates smoothly into the most complex
systems. For more information, see the Menu System later in this manual.
3 Touchscreen
The front panel touchscreen is used for day-to-day operation of the CP-
800. It is also used for setup and to display useful information as required.
4 5 6 7
MUTE
8