Front Panel Controls - Classe Audio CP-40 Owner's Manual

FRONT PANEL CONTROLS

INPUT SELECTOR:
This selects one of the five inputs connected to the preamplifier, except TAPE IN (see TAPE
SWITCH below). The selector switch is silent and will prevent pulses when switching positions.
However, it remains good practice to reduce the volume control level or put MUTE to ON (steady
GREEN LED) when changing the input selection.
TAPE SWITCH:
In the SOURCE position, the preamp will process the signal as chosen by the INPUT
SELECTOR. In the TAPE position, the preamp will process the TAPE INPUT signal, overriding the
INPUT SELECTOR.
BALANCE CONTROL:
The custom balance control permits equal output of each channel in the center (detented)
position without additional loading to the signal. When shifted to the left or right, it merely
attenuates the opposite channel.
VOLUME CONTROL: (remote control)
The VOLUME CONTROL varies the output level of both channels simultaneously. It can be
operated by remote using the hand held control unit (see fig.1 Page 14) or manually turning the
control knob at the preamp.
9