Brightness; Timeout; Volume Setup - Classe Audio CP-800 Owner's Manual

Brightness

The Brightness setting of the CP-800 touchscreen has three possible values: low,
medium, and high. Select the setting you prefer. A high brightness setting usually
works best in brightly-lit rooms; you may find that a lower setting is less visually
intrusive under more subdued lighting conditions.

Timeout

If you prefer listening to music in a dimly-lit or darkened room, you may
find even the low brightness setting of the display somewhat distracting. You
can essentially turn off the touchscreen by reducing the timeout value of the
backlighting so as to turn it off entirely after a period of inactivity that you
may select. In this context, activity refers to any use of the user interface. This
includes hard buttons, the touchscreen, and the remote control.
For example, if you reduce the timeout to its minimum setting, the backlighting
illuminates the display as soon as you interact with any of the CP-800 controls,
and remains lit for only three seconds – just long enough for you to check a
setting. If you continue to use any of the controls (at least once every three
seconds), the display remains lit. After three seconds of inactivity on your part,
the backlight extinguishes itself, essentially turning off the touchscreen.
If you prefer the display of the CP-800 to remain on whenever not in Standby
mode, select the Never timeout option. The lamp in the touchscreen display is
designed for harsh automotive environments and will give you many years of
reliable operation. If you plan to leave the unit on continuously, however, we
recommend that you keep the timeout delay set to less than one minute.

Volume Setup

Touching the Volume Setup button in the System Setup menu opens the
Volume Setup page, as shown below. The volume knob is used to make all
volume setup adjustments.
Volume Setup allows you to:
NOTE: setting the brightness to a lower setting does not increase
the life of the lamp.
• set a maximum volume level;
• choose an initial volume level for the system whenever the CP-800 is
brought out of Standby;
• customize the behavior of the mute control.
29