Teach Ir; Tone Control - Classe Audio CP-800 Owner's Manual

Teach IR

The complete list of CP-800 discrete infrared (IR) command codes extends
beyond what is practical for any one handheld remote control. However, many
of these functions are critical if you plan to create a customized remote control
with macros that take command of your entire system. Without these discrete
codes, many of the macros you might want to create simply won't work reliably.
The Teach IR page displays a scrolling list of all the available IR codes in the
CP-800. Simply scroll to the command you want your macro-capable remote to
learn and touch the Send IR Code button. The CP-800 continuously sends that
command code via the front panel - as long as the button is pressed – until your
third-party remote control has learned it.
For more information on control systems, we recommend you speak with your
authorized Classé dealer.

Tone Control

Setting up the Tone Control involves choosing high and low frequency inflection
points, and relative cut or boost for them. The factory default settings create
what is called a tilt control, which tilts the tonal balance either toward more
high and less low frequency for a leaner, crisper sound, or the opposite direction
toward a warmer, fuller sound.
If conventional bass and treble controls are preferred they may be configured
using the Tone Control Setup page as described in the Menu System section.
Press Tone on the remote or MENU then Tone Control on the touchscreen to
access the tone control. The Tone Control is activated by selecting the Enable
box on the touchscreen. Alternatively, pressing Tone on the remote control
switches to the Tone Control screen and each subsequent press toggles the
control on and off. When the Tone Control is enabled, Tone appears in a box on
the Home page. The Volume up/down buttons on the remote and the volume
knob on the unit are used to increase or decrease the effect of the Tone Control
when in tilt mode. When used as conventional bass and treble controls, the
Boost and Cut buttons on the touchscreen are used for increasing or decreasing
the corresponding Tone Control levels. These controls may also be accessed
by pressing Tone on the remote control and using the navigation keys. The
adjustment range is +/- 6 dB in 0.5 dB increments.
NOTE: To change these parameters, press MENU, then System
Setup, Tone Control Setup.
35