Advertisement
FRONT PANEL CONTROLS
INPUT SELECTOR:
The input selector (see fig.4, page 15) has two buttons for selecting the inputs; (<) and (>).
Pressing the < button selects the input to the left of the currently selected input, and pressing the >
button selects the input to the right of the currently selected input. If the > button is pressed when
BAL1 is the current input then the REG1 input will be selected, and if the < button when REG1 is
the current input then the BAL1 input will be selected. The < and > buttons will select from five
input connections on the preamplifier, but not the TAPE, (see TAPE below).
TAPE
In the SOURCE position (TAPE LED OFF), the preamp will process the signal as chosen by
the INPUT SELECTOR. In the TAPE position (TAPE LED ON (RED)), the preamp will process the
TAPE INPUT signal, overriding the INPUT SELECTOR.
VOLUME CONTROL
The VOLUME CONTROL varies the output level of both channels simultaneously. It can be
operated by remote using the hand held control unit (see fig.4, Page 15) or manually turning the
control knob at the preamp. The volume control has a total of 120 steps of level adjustments
form 0 to 60 in 0.5 stepped increments. When the unit is plugged in, the display will count down
from 20 to 0. When the countdown has resumed, the volume will be
11
C-103 Issue 2 November '97
Advertisement
