Configuration Setup; Configuration Name; Configure Outputs - Classe Audio CP-800 Owner's Manual

NOTE: It is possible to generate a subwoofer output for an analog source without
converting that source to digital. If Digital Bypass is NOT selected, the HP Filter
is NOT selected in the configuration and no other DSP functions are called, then
L&R signals will remain in the analog domain while a subwoofer output is generated
according to the crossover and slope settings for that configuration.

Configuration Setup

The Configuration Setup page allows you to define up to six different speaker
configurations. Touch the button for the specific configuration you want to set
up to open its configuration setup menu. The page contains buttons for naming
the configuration and enabling balanced (XLR) and/or single-ended (RCA)
outputs for Main, Aux and Subwoofer channels. Choosing a subwoofer output
causes a Bass Management button to appear. The same menu is used to set up
each configuration.

Configuration Name

As with naming sources, press the Configuration Name button to access the
keyboard used for customizing the configuration name. Remember to press Enter
after making your changes to save the new name.

Configure Outputs

Choose the output connectors you want enabled with this configuration. If a
subwoofer (or two) is used, a Bass Management button appears, allowing you to
set crossover frequency and slope, or enable stereo or two mono subwoofers.
27