The Remote Control - Classe Audio CP-800 Owner's Manual

1
2
3
CONFIG
SELECT
SOURCE
SELECT
4
MENU HOME
5
TONE BAL
6

The Remote Control

Your CP-800 Stereo Preamp/Processor includes a versatile IR remote control for
both the Preamp/Processor itself and several aspects of the rest of a Classé-based
system. The buttons are arranged in logical groups according to their functions.
The remote control of the CP-800 is shown on the left. The numbers in the
drawing refer to the descriptions that follow.
1 Basic Functions
The two buttons along at the top of the remote control groups the
following basic control functions:
• Light turns on the backlighting of the remote control for better
visibility under low-light conditions. After a few moments of
inactivity, the backlight switches off automatically.
• Standby switches the CP-800 between the Standby and Operate
states.
2 Volume Control & Mute Buttons
The Volume Up and Down arrow buttons increase or reduce the overall
volume level of the audio output. Pressing the Mute button reduces the
audio output volume level by a pre-determined amount. You can customize
selected features of both the Mute button and volume level. Refer to the
Volume Setup description in the Menu System section found later in the
manual for further instructions.
3 Config Select Buttons
The left and right arrow buttons step through the six configurations. If
there is a different configuration assigned as a default for a particular source
it will be overridden until the source is selected again, or you select that
particular default configuration.
Pressing the CONFIG SELECT button will open the configurations page,
making it easier to navigate to a specific configuration. Use the positions of
the underlined buttons on the screen rather than trying to read their names
from across the room.
4 Source Select Buttons
To change inputs, simply use the Source Select arrow buttons to step
through the inputs.
Pressing the SOURCE SELECT button will open the Source Selection
page, making it easier to navigate to a specific source. Use the positions of
the underlined buttons on the screen rather than trying to read their names
from across the room.
To keep your input selection list smaller and easier to navigate, the Source
Select buttons will toggle only through those inputs which are enabled.
Refer to the Menu System section found later in the manual for further
instructions.
17