Advertisement
FRONT PANEL CONTROLS
NOTE: All functions may be activated directly on the front panel, or otherwise by the hand held remote
control.
DISPLAY:
Three (3) different display brightness levels can be selected (Full/Medium/Low as well as Off).
NOTE: With display set at the OFF position, activating any switches on the front panel or from the
remote control unit will temporarily turn the display to ON at full brightness. The display will
automatically turn back to OFF after approximately 10 seconds from the last change.
GAIN:
The dual gain feature provides the user to set the preamplifier either at REGULAR gain of 18db
or LOW gain of 12db. The red indicator "GAIN" appears in the display when LOW gain is selected.
PHASE:
Phase of the output signal can be switched between inverted (180 degrees phase shift) or normal
non-inverted (0 degree phase shift). The red indicator "PHASE" is shown when the unit is in the
inverted mode.
TAPE
The TAPE button selects the input signal, between the TAPE and SOURCE inputs, which goes
to the main REGULAR and BALANCED output jacks. The red indicator "TAPE" appears when Tape
input is selected. However, the SOURCE signal always appears at the TAPE OUT jacks and shown in
the display.
-9-
Advertisement
