Classe Audio CP-800 Owner's Manual page 15

7 IR Input
Use the IR input when the front panel IR window does not have a clear
line-of-sight with the remote control, for instance, when the CP-800 is
installed in a cabinet. Attach this input to an infrared repeater system to
route signals from the remote control to the CP-800 via a mono mini-jack
(3.5mm phono).
The list of available IR command codes can also be used in macros for
sophisticated remote control systems, facilitating the control of the
CP-800 in the larger context of the complete system.
8 IR Output
Use the IR output to pass IR commands from an external IR transmitter
through the CP-800 to another component, when necessary. The output
uses a mono mini-jack (3.5mm phono) with the same properties as the
diagram in the previous section.
9 Trigger Outputs
The CP-800 supports two trigger outputs, with mono mini-jacks (3.5mm
phono) labeled OUT1 and OUT2. Each trigger outputs a 12V DC signal
at 100 mA and each can be controlled individually. Use these outputs to
control other system components such as amplifiers and window blinds.
Refer to the Triggers description in the Menu System section for more
details.
10 RS-232 Port
The primary purpose of the RS-232 port is to support the use of external
commands to allow remote control of the CP-800 by such systems as
®
AMX , Control 4, Creston
these systems, contact your Classé dealer.
11 CAN-Bus Input and Output
CAN-Bus (Controller Area Network) allows several Classé components to
be connected together for simultaneous operation, such as switching from
On to Standby. Using the CAN-Bus Input and Output connectors, the
Classé components can be daisy chained together and controlled via the
CAN-Bus interface.
NOTE: The final component in the daisy chain MUST have a
termination plug inserted into the CAN-Bus output.
For more information, refer to the CAN-Bus section found later in this
manual.
®
and Savant . For more information about
TM
15