Front Panel Controls - Classe Audio CAP-100 Owner's Manual

FRONT PANEL CONTROLS

POWER
When the POWER BUTTON is pressed, this will initialise the start up mode, the MUTE
LED will be flashing for 30 seconds. During these 30 seconds, there will be no response from the
remote control functions, the mute button, the tape button and the separate button, only the power
button can be reactivated to turn off the unit during this sequence.
INPUT SELECTOR
This will select one of the seven inputs connections on the integrated amplifier, except TAPE
IN (see TAPE BUTTON) and AMP IN (see SEPARATE). The selector switch is silent and will
prevent pulses when switching positions. However, it remains good practice to REDUCE THE
VOLUME CONTROL LEVEL or to activate MUTE ON (steady GREEN LED) when changing the
input selection.
TAPE
In the SOURCE position, the integrated amplifier will process the signal as chosen by the
INPUT SELECTOR. In the TAPE position, the preamp will process the TAPE INPUT signal,
overriding the INPUT SELECTOR.
CAP100, Issue 2, June 97
10