Using The Cp-800; Source Selection - Classe Audio CP-800 Owner's Manual

Using the CP-800

The CP-800's versatile touchscreen LCD supports your day-to-day operations
and provides access to a flexible menu system for controls and setup functions
that aren't accessed as often. This section of the owner's manual outlines the use
of the touchscreen in routine operation of the system.
When you bring the CP-800 out of Standby mode, the touchscreen displays the
Home page of the menu system, as shown below.
The Home page displays the volume in large font which is easily visible from
across a room. The selected source appears at the bottom of the screen. At the
bottom center of the screen the format of the incoming signal is displayed.
This displays the sampling frequency of digital sources as well as the file format
(ALAC, WAV, FLAC, etc.) of streaming Network sources or Bypass if so selected
for analog sources. If Pass-Thru is selected for either digital or analog sources,
the volume display will read 0.0 and be greyed out (since the volume control
is not active in this mode). This page can be quickly accessed at any time by
pressing the Home button on the remote control or tapping the home icon on
the touchscreen display.

Source Selection

Touching the screen when on the Home page brings up the Source Selection
page. The number of source buttons appearing here corresponds to the number
of inputs that have been set up and are "enabled." A maximum of nine sources
may appear on one page. If more are enabled, they will be available on the next
page by touching the button in the upper right corner of the page. See the
section on source setup in the Menu System. The CP-800 has up to 18 selectable
source buttons which are all interchangeable.
22