Front Panel Controls - Classe Audio CAP 80 User Manual

FRONT PANEL CONTROLS

POWER
When the unit is first plugged in, a single LED will be lit on the display to show that the unit
is plugged in When the POWER button is pressed, a single LED in the display will flash and the
.
display will show a 20 second count down as the unit powers up. During these 20 seconds, there will
be no response to any function selection except the POWER button, which can be pressed again to
turn off the unit during this sequence. Please note that if you turn off the unit during the 20
second power-up sequence, you must wait at least 4 seconds to re-start the power-up sequence.
INPUT SELECTOR
The input selector has two buttons for selecting the inputs; (<) and (>). Pressing the < button
selects the input to the Left of the currently selected input, and pressing the > button selects the input
to the Right of the currently selected input. If the > button is pressed when BAL1 is the current input
then the REG1 input will be selected, and if the < button is pressed when REG1 is the current input
then the BAL1 will be selected. The < and > buttons will select from six input connections on the
integrated amplifier, but not TAPE, (see TAPE below.)
TAPE
Pressing the TAPE button selects the signal from the TAPE INPUT jacks to play through the
speakers. You can use this function to either listen to pre-recorded tapes or to monitor the
quality of a recording you are making of another selected source. The Red LED above the TAPE
button will glow to identify that the TAPE input has been selected.
8
CAP80, Issue 1, June 97