Rear Panel; Serial Number - Classe Audio CP-800 Owner's Manual

5
1
14 15
100-240V~
T2AL250V
USB
GND
ANALOG AUDIO IN
R1 L1 R2 L2 R3

Rear Panel

The rear panel of the CP-800 is shown above. The numbers in the drawing refer
to the descriptions in this section.

serial number

You'll find your CP-800 serial number on the top right corner of the rear panel,
as shown in the graphic above. Please record this number for future reference.
And since you have found the serial number, please use it to register your
purchase, if you haven't done so yet. We may use the information to advise you
of any updates or other items of interest. Registration is simple, so please register
online at www.classeaudio.com or fill out the registration card and drop it in the
mail.
1
2
2 6 3
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TOT HE FOLLOWING TWO CONDITIONS:
(1)T HIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,A ND
(2)T HIS DEVICE MUSTA CCEPTA NY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCETH AT MAYC AUSE UNDESIRED OPERATION.
DIGITAL INPUT
AES/EBU
COAX1 COAX2 COAX3
R4 L4 R5
L3
Digital Audio Input - USB
The CP-800 supports digital audio sources up to 24-bit/192 kHz via USB.
The rear panel USB Device connector mates with a USB Host such as a
PC or Mac. Note: Earlier generations of the CP-800 were limited to 96 kHz
via USB. An available upgrade kit may be installed to enable the 192 kHz
USB feature as well as Ethernet-related features described elsewhere in this
manual.
Digital Audio Input - AES/EBU
The CP-800 provides an XLR type connector for digital audio connections
from source components such as CD players fitted with this professional-
standard output. These inputs accept PCM data streams up to 24-bits
long and up to 192 kHz sampling frequency. We recommend using cables
that are optimized for digital audio signal transfer and that carry a 75Ω
impedance rating. Your Classé dealer can help you with proper cable
selections.
7 8 9
4
CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK, GROUNDING
OF THE CENTER PIN OFT HIS PLUG MUST BE MAINTAINED
AVIS! POUR RÉDUIRE LE RISQUE DE CHOC ÉLECTRIQUE
LA FICHE CENTRALE DE LA PRISE DOIT ÊTRE
OPT1 OPT2 OPT3 OPT4
BRANCHÉE POUR MAINTENIR LA MISE À LAT ERRE
IR TRIGGER
IN OUT OUT1 OUT2
ANALOG AUDIO OUT
L5
MAIN R MAIN L
10 11 12 13
CAN IN CAN OUT ETHERNET
RS-232
AUX2 AUX1 SUB
13