AXIS 5470e User's Manual
Using ARP in UNIX
Using RARP in UNIX
Follow the instructions below to set the IP address using ARP:
Type the following commands in the shell window:
arp -s <host name> <Ethernet address> temp
ping <host name>
Example:
arp -s npsname 00:40:8c:10:00:86 temp
ping npsname
The host will return
This indicates that the address has been set and that communication
is established.
Notes:
•
Ethernet address
The
located on the underside label of the AXIS 5470e.
•
The ARP command varies between different UNIX systems. Some BSD
type systems expect the host name and node address in reverse order. Fur-
thermore IBM AIX systems will require the additional argument ether.
Example:
arp -s ether <host name> 00:40:8c:10:00:86 temp
•
When you execute the ping command for the first time, you may experi-
ence a significantly longer response time than usual.
Follow the instructions below to set the IP address using RARP:
1. Append the following line to your Ethernet Address table. This is
typically located in the
<Ethernet address> <host name>
00:40:8c:10:00:86 npsname
2. Update, if necessary, your host table and alias name databases,
as required by your system.
Section 3: Basic Installation
npsname is alive,
is equal to the serial number, which is
file:
/etc/ethers
or a similar message.
29