Axis 5470e User Manual page 185

AXIS 5470e User's Manual
Mainframe Specific
Parameters
AS/400 Specific
Parameters
Parameter Name
NODE_ID Node ID
This is the SNA PU identification.
The first 3 digits is the IDBLK and the last five is the IDNUM.
When defining a VTAM Switched Major Node, this parameter should match the IDBLK and IDNUM values
specified in the PU definition.
Only Hexadecimal characters (0-9 and A-F) allowed.
Parameter
NWORK_NAME
Description - This is the Print Server Network Name.
The value of this parameter is normally the same as the "Host Network Name", indicating that both the
Print Server and the AS/400 system are located on the same APPN network.
The Network Name may comprise the letters A-Z and/or numerals 0-9, but must begin with a letter.
The letters used should all be in UPPERCASE and a maximum of 8 characters are allowed.
LU_NAME
Description - Axxxxxxx, where "xxxxxxx" is the last 7 characters of the AXIS 5470e serial number, in
reverse order, e.g.
if s.no. =
00 40 8C 1B 06 D4 the default LU Name =
A4D60B1C.
This will be the name of the APPC device and controller
created during auto-configuration
Description - Axxxxxxx, where "xxxxxxx" is the last seven characters of the Print Server serial number, in
reverse order, i.e. a print server with serial number 00 40 8C 1B 06 D4 will have the default CP Name
A4D60B1C. This will be the name of the APPC controller created during auto-configuration.
H1_NW_NAME
H1_LU_NAME
Section 15: SNA Parameter Overview
Default
E07xxxxx, where "xxxxx" are the last five digits of the
Print Server's MAC address.
Name Default
Network Name APPN
LU Name Axxxxxxx
Host Network Name APPN
DEFAULT
Host LU Name
185
Emulation
5494 only
5494 only
5494 only.
5494 only