Axis 5470e User Manual page 86

Network print server
Hide thumbs Also See for AXIS 5470e:
Table of Contents

Advertisement

Section 5: Setting Up - IBM Mainframe
86
PRTnnnn Statement
PRMODE
SEP
SEPDS
START
TRKCELL
UCS
JES3 Initialization
Explanation
Specifies the data-set processing modes supported for the printer. It lists all the PRMODE values that the
printer accepts. If the AXIS 5470e is connected to a PostScript printer, the correct setting is
PRMODE=(PAGE,LINE,)
printed.
Enables job-header and job-trailer separator pages to be produced.
Note1: If the Distributed Print Function (DPF) of PSF/2 is installed, you may need to set
this parameter to
.
YES
Note2: This parameter is new in JES2 and replaces the SEP | NOSEP parameter.
Enables formatted data-set header separator pages to be produced.
Note: This parameter is new in JES2 and replaces the SEPDS | NOSEPDS parameter.
Specifies the way that the printer is started. The parameter value
by an operator command. The parameter value
automatically when JES2 starts processing.
Note: This parameter is new in JES2 and replaces the DRAIN | START parameter.
Specifies whether track-cell despooling is to be used or not. It is recommended to set this parameter to
Specifies a default font. If you want to select a font in the startup procedure instead of the JES2 default font,
you should set this parameter to
Below is sample JES3 statements for an TCP/IP attached AXIS 5470e.
In the example the JNAME=PRT1 has been used.
FSSDEF,TYPE=WTR,FSSNAME=FSS3,PNAME=SAMPPRO3,SYSTEM=SYS1,TERM=NO
DEVICE,DTYPE=PRTAFP1,JNAME=PRT1,JUNIT=(,SYS1,,ON),FSSNAME=FSS3
MODE=FSS,PM=(LINE,PAGE,),CHARS=(YES,GT12),
CARRIAGE=(TES,A868),CKPNTPG=100,HEADER=YES,WC=(C)
Note:
This is only an example. For specific coding for JES parameters, refer to the JES
publication for the level of JES you are using.
The following paragraphs describe the JES3 initialization statements
shown above, which are typical of the JES3 statements used with
PSF. For more detailed descriptions of all JES3 initialization
statements, refer to the JES3 initialization and tuning publication for
your operating system.
.. This setting indicates that composed-page and line data sets can be
specifies that the printer, if it is ready, is to start
YES
.
0
AXIS 5470e User's Manual
specifies that the printer is to be started
NO
.
YES

Advertisement

Table of Contents
loading

Table of Contents