Axis 5470e User Manual page 90

Section 5: Setting Up - IBM Mainframe
90
Defining the
printer to PSF
Each AXIS 5470e must be defined to PSF with a PRINTDEV statement
in the PSF startup procedure. The following keywords are required on
the PRINTDEV statement:
• IPADDR='xxx.xxx.xxx.xxx'
• PORTNO='xxxx'
The IPADDR parameter specifies the IP address of the AXIS 5470e in
dotted-decimal notation.
Note:
Do not specify a host name in place of the dotted-decimal address.
The PORTNO keyword specifies the TCP/IP port to use for the print
session. This port number must match the port number set up for the
AXIS 5470e in Configuring the AXIS 5470e, on page 65.
Below is a sample procedure,
your installation. The
and keywords. In the
IPADDR PORTNO
TCP/IP port number 5100 is used, but any port, larger that 1024, can
be used as long as the same port is set up in the AXIS 5470e.
The procedure contains JCL parameters to produce a
APSWPROT
startup procedure for either 240-pel and 300-pel printers, but the
references to 300-pel resolution are commented out. To create
separate startup procedures, make two copies of
follow the commented instructions in
unchanged copy as your startup procedure for a resolution of 120 or
240 pels. In the second copy, delete or comment out all references to
240-pel resolution, and make all references to 300-pel resolution
active. This changed copy is your startup procedure for 300-pel
resolution.
If you want to print both 240-pel and 300-pel AFP/IPDS jobs, create
two separate FSAs, one for jobs with resolution of 120 or 240, and
one for jobs with resolution of 300 pels. The 240-pel resolution FSA
uses 240-pel resources, and the 300-pel resolution FSA uses 300-pel
resources. Both FSAs are defined to drive the same printer; however,
AXIS 5470e User's Manual
, which you can modify to suit
APSWPROT
statement includes the required
PRINTDEV
PRINTDEV
APSWPROT
example below, the
, and then
APSWPROT
. Keep one