Axis 5470e User Manual page 30

Section 3: Basic Installation
30
Using BOOTP
3. If it is not already running, start the RARP daemon. This is
typically performed using the
4. Restart the AXIS 5470e to download the IP address.
Notes:
• The Ethernet address
found on the underside label of the AXIS 5470e.
• If you are a IBM AIX user, you will probably not have access to a RARP
daemon. If this is the case, you can use either the ARP or BOOTP methods
instead.
Follow the instructions below to set the IP address using BOOTP:
in UNIX
1. Append the following entry to your boot table. This is typically
performed by editing the file:
<host name>:ht=<hardware type>:vm=<vendor magic>:\
:ha=<hardware address>:ip=<IP address>:\
:sm=<subnet mask>:gw=<gateway field>
npsname:ht=ether:vm=rfc1048:\
:ha=00408c100086:ip=192.168.3.191:\
:sm=255.255.255.0:gw=192.168.1.1
The AXIS 5470e can automatically download a customized config file
from a TFTP server. Just add the name of the config file and the TFTP
server's IP address to your boot table. The config file is downloaded
immediately after the AXIS 5470e receives its IP address.
AXIS 5470e User's Manual
command.
rarpd -a
is equal to the serial number, which can be
/etc/bootptab