Axis 5470e User Manual page 216

216
Section 20: IPDS Overview
Duplex Support
Optimize Duplex
Default output bin
Default input bin
IPDS bin 1-5
The Duplex Support setting determines whether duplex support for
the attached printer shall be reported to the host. Enabled means
that duplex commands are transferred to the printer. Disabled means
that duplex printing is not supported. The default setting is Disabled.
Use this option to optimize duplex print jobs. Optimization means
that sheets are printed in simplex if the reverse side of the sheet is
empty, resulting in higher throughput.
Note:
Some printers will internally turn the sheet upside down when duplex is used. this
may cause undesired effects when using pre-printed forms. Setting this
parameter to No will force the entire job to be printed in duplex mode
N-up The N-up parameter defines if 1, 2 or 4 pages in your document are
to be printed on each physical page.
This selection defines which output paper bin should be used as
default.
The default selection is Bin 1.
This selection defines which input paper bin should be used as
default.
The default selection is Bin 1.
The physical paper size selection must match the actual paper size
you are using for Bin 1-5. The predefined sizes are Statement, Ledger,
Folio, Hagaki, Executive, Letter, Legal, A4 and A3.
The default size is A4.
If you are using another paper format, select Custom. This selection
requires that you define the paper size by setting the parameters
Physical Paper Width and Physical Paper Length to the appropriate
values.
AXIS 5470e User's Manual