Removing the Main Tray Assembly
Perform the following steps to remove the Main Tray Assembly:
1 Power off the system, the monitor, and any peripheral devices. Unplug the system
NOTICE:
There is no need to manually shut down the HP-UX operating system on
your workstation before powering it off. When you turn off the power
switch, your workstation automatically shuts down the operating system
before terminating the power.
2 Disconnect cables from any peripheral devices.
3 Attach a static-grounding wrist strap to bare metal on the back panel of the system
4 Completely loosen the four captive screws on the rear of the system unit, as
Captive Screws
Figure 35
unit power cord and the power cord of any peripheral devices from ac wall out-
lets. Disconnect the power cord from the system unit.
unit.
shown in Figure 35.
Removing Main Tray Assembly
Changing Your Workstation's Hardware Configuration
Removing the Main Tray Assembly
Captive
Screws
139