Recording - Roland JUNO-Gi Owner's Manual

Recording

Entering normal mode
1. In the RECORDER screen, press the [1] (MODE) button a
number of times to select Normal mode.
Make sure that the display does not indicate "BOUNCE" or
"MASTERING. "
Mode indication (use the [1] (MODE) button to switch)
(unlit) This means you're in Normal Recording mode.
BOUNCE This means you're in Bounce mode (p. 97).
MASTERING
This means you're in Mastering mode (p. 118).
Selecting the track to record
MEMO
If you want to switch V-tracks, select the desired V-track now as
described in "Switching V-tracks (V-Track)" (p. 89) before you proceed.
2. Press the [l] (REC) button.
The [l] (REC) button will blink, and the digital recorder will be in
recording standby condition.
In recording-standby mode, one of the TRACK [1/5]–[4/8] buttons (the
track to record) will blink red.
3. Press the[1/5]–[4/8] button of the track you want to record.
Button Explanation
When [TRACK 1–4 5–8] is unlit
[1/5]–[4/8]
Select tracks 1–4.
When [TRACK 1–4 5–8] is lit
[1/5]–[4/8]
Select tracks 5–8.
MEMO
Even when you're not in recording-standby mode, you can select
the track to record by holding down the [SHIFT] button and
pressing a TRACK [1/5]–[4/8] button.
94
Selecting stereo tracks for recording
If INPUT is set to "KEYBOARD", "LINE" or "USB"
Since the input is stereo, this will normally be stereo recording
using two tracks. If you press the TRACK [1] or [2] button,
recording will take place in stereo on tracks 1 and 2. Similarly
if you press the [3] or [4] button, recording will take place in
stereo on tracks 3 and 4.
However if you want to mix the sound from the L-channel and
R-channel of the input and record it on track 1, press the TRACK
[1] button once again from the state in which tracks 1 and 2 are
selected. Track 1 will be selected as the recording destination.
You can use the same operation to specify a different track as
the recording destination.
If INPUT is set to "GUITAR" or "MIC"
If you want to record in stereo so that the insert effects will
sound better, you can simultaneously press the TRACK [1] and
[2] buttons or [3] and [4] buttons to specify stereo recording
using two tracks.
Stereo link (p. 89) will be enabled (or disabled) for the pair of
tracks you pressed simultaneously.
Recording
4. Press the [ ] (PLAY) button.
The [l] (REC) and [ ] (PLAY) buttons will light, and recording will
begin. The button of the track being recorded will light red.
5. To stop recording, press the [n] (STOP) button.
The [l] (REC) and [ ] (PLAY) buttons will go dark.
* You can't play back audio whose recording time was shorter than
one second.
* The following operations cannot be performed (or will be invalid)
while the recorder is operating (i.e., during recording or playback).
• Recorder Menu
• Undo/Redo
• Switching a mode ([1] (MODE) button)
• Arrange editing, etc...