14: Infinite Phaser; Infinite Phaser; 15: Ring Modulator; Ring Modulator - Roland JUNO-Gi Owner's Manual

14: INFINITE PHASER

A phaser that continues raising/lowering the frequency at which the sound is
modulated.
L in

Infinite Phaser

R in
Parameter Value
Mode 1, 2, 3, 4
Speed # -100–+100
Resonance # 0–127
Mix # 0–127
Pan # L64–63R
Low Gain -15–+15 dB
High Gain -15–+15 dB
Level 0–127

15: RING MODULATOR

This is an effect that applies amplitude modulation (AM) to the input signal, producing
bell-like sounds. You can also change the modulation frequency in response to
changes in the volume of the sound sent into the effect.
L in
Ring Mod 2-Band EQ
R in
Ring Mod 2-Band EQ
Parameter Value
Frequency # 0–127
Sens # 0–127
Determines whether the frequency modulation moves
towards higher frequencies or lower frequencies.
Polarity
UP
DOWN
Low Gain
-15–+15 dB
High Gain -15–+15 dB
Balance # D100:0W–D0:100W
Level
0–127
54
L out
Pan L
2-Band EQ
Pan R
R out
Explanation
Higher values will produce a
deeper phaser effect.
Speed at which to raise or
lower the frequency at which the
sound is modulated (+: upward /
-: downward)
Amount of feedback
Volume of the phase-shifted
sound
Panning of the output sound
Amount of boost/cut for the
low-frequency range
Amount of boost/cut for the
high-frequency range
Output volume
L out
R out
Explanation
Adjusts the frequency at which
modulation is applied.
Adjusts the amount of frequency
modulation applied.
Higher frequencies
Lower frequencies
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the
direct sound (D) and the effect
sound (W)
Output level

16: STEP RING MODULATOR

This is a ring modulator that uses a 16-step sequence to vary the frequency at which
modulation is applied.
L in
Step Ring Mod
R in
Step Ring Mod
Parameter Value
Step 01-16
0–127
Rate # 0.05–10.00 Hz, note
Attack # 0–127
Low Gain -15–+15 dB
High Gain -15–+15 dB
Balance # D100:0W–D0:100W
Level 0–127
MEMO
You can use multi-effect control to make the step sequence play again from
the beginning (p. 46).

17: TREMOLO

Cyclically modulates the volume to add tremolo effect to the sound.
L in

Tremolo

2-Band EQ
R in
Tremolo
2-Band EQ
Parameter Value
Modulation Wave
TRI
SQR
SIN
Mod Wave
SAW1/2
SAW1
Rate # 0.05–10.00 Hz, note
Depth # 0–127
Low Gain
-15–+15 dB
High Gain -15–+15 dB
Level
0–127
L out
2-Band EQ
R out
2-Band EQ
Explanation
Frequency of ring modulation at
each step
Rate at which the 16-step
sequence will cycle
Speed at which the modulation
frequency changes between
steps
Amount of boost/cut for the
low-frequency range
Amount of boost/cut for the
high-frequency range
Volume balance of the original
sound (D) and effect sound (W)
Output volume
L out
R out
Explanation
Triangle wave
Square wave
Sine wave
Sawtooth wave
SAW2
Frequency of the change
Depth to which the effect is
applied
Gain of the low range
Gain of the high range
Output Level