Playing Back Repeatedly (Repeat); Specifying The A-B Region; Using The A-B Setting Screen To Specify The Repeat; Region - Roland JUNO-Gi Owner's Manual

Playing Back Repeatedly (REPEAT)

The "repeat" function lets you play back a specified region repeatedly.
This function is useful when you want to check the mix balance
repeatedly, or can be used in conjunction with punch-in/out to
perform Loop Recording (p. 96).
Specifying the A–B Region
1. Move to the point where you want to begin repeating (point
A), and press the [REPEAT] (A
The "A B" indication will blink in the display, and that location will
be registered as the starting point (A) of the repeated region.
2. Move to the point where you want to stop repeating (point
B), and press the [REPEAT] (A
At this time, the "A B" indication will light, indicating that the A–B
region has been assigned.
• When specifying the repeat end point (B), pressing the [REPEAT] (A
B) button at a point that is earlier than the repeat start point (A) will
cause that point to be reassigned as the repeat start point (A).
• There must be at least one second between the repeat start point (A)
and end point (B). You can't specify an end point that's less than one
second away from the start point.
MEMO
You can also set the A-B region by pressing the [REPEAT] (A
button while the song is playing.
90
B) button.
B) button.
B)
Using the A–B SETTING Screen To Specify the
Repeat Region
3. Hold down the [SHIFT] button and press the [REPEAT] (A
B) button.
A–B SETTING screen will appear.
Current Time
Location of point A
Function button
Button Function
The region you specified (A–B) will be
[1] (REPEAT)
assigned as the repeat region.
The region you specified (A–B) will be
[2] (AUTO)
assigned as the auto punch-in/out region.
The region you specified (A–B) will be
assigned as the auto punch-in/out region.
[3] (R&A1)
The A–B region will be assigned as the
repeat region.
The region you specified (A–B) will be
assigned as the auto punch-in/out region.
[4] (R&A2) One measure before and after the A–B
region will be assigned as the repeat

region.

The location data at the cursor will be
[5] (CLEAR)
cleared.
[6] (EDIT) The track edit menu will open.
4. Press the [1] (REPEAT) button.
The region you specified will be assigned as the repeat region.
Repeat
Playback
A
5. Press [EXIT] button to close the A–B SETTING screen.
In the RECORDER screen, "
MEMO
• If you want to cancel the repeat, press the [REPEAT] (A
button once again. The repeat settings will be cancelled, and the
"A B" will be unlit.
• If you want to preserve the repeat region you specified, press the
[WRITE] button to save the song.
Location of point B
Page
––
p. 95
p. 96
p. 96
––
p. 98
Time
B
" and "A B" will be displayed.
B)