Signal Flow And Parameters (Effect Routing) - Roland JUNO-Gi Owner's Manual

Signal Flow and Parameters
(EFFECT ROUTING)
Here you can make overall settings for effects, such as the output
destination and level of the various signals.
7
4
1
2
5
3 8
6
The parameters listed below in 7, 9–11 can be edited for each of the
three multi-effects (MFX1–MFX2).
Num-
Parameter Value
ber
UPPER 1,
UPPER 2,
1 Layer Select
LOWER 1,
LOWER 2
Specifies how the unprocessed sound of each layer will
be output
MFX
Layer Output L+R
2
Assign
L
R
3 MFX Select 1–2
Layer Output
4 0–127
Level
Layer Chorus
5 0–127
Send Level
Layer Reverb
6
0–127
Send Level
7 MFX Type
0–79
8 MFX Structure 1–3
MFX Output
9 0–127
Level
MFX Chorus
10 0–127
Send Level
MFX Reverb
11 0–127
Send Level
Type of chorus
0 (OFF)
12 Chorus Type 1 (CHORUS)
2 (DELAY)
3 (GM2 CHO)
9
12
10
14
13
11 15
Explanation
The layer for which to make settings
Output in stereo via the multi-effect.
Chorus and reverb can also be applied
after the multi-effect.
Output in stereo from the OUTPUT
jacks without passing through the
multi-effect
Output in mono from the OUTPUT
L jack without passing through the
multi-effect
Output in mono from the OUTPUT
R jack without passing through the
multi-effect
Multi-effect used by the layer (choose
one of MFX 1, 2)
Level of signal sent to the destination
specified by Layer Output Assign
Level of signal sent from each layer to
the chorus
Level of signal sent from each layer to
the reverb
Type of multi-effect to use (choose
one of 79 types)
For details on each multi-effect, refer
to "Multi-Effects Parameters (MFX1,
2)" (p. 48).
How MFX 1, 2 will be combined (p. 46)
Volume of the sound that has been
processed by the multi-effect
Amount of chorus applied to the
sound that has been processed by the
multi-effect
Amount of reverb applied to the
sound that has been processed by the
multi-effect
Chorus/delay will not be used
Chorus
Delay
GM2 chorus
Num-
Parameter Value
ber
Type of reverb
0 (OFF)
1 (REVERB)
2 (SRV ROOM)
13 Reverb Type
3 (SRV HALL)
4 (SRV PLATE)
5 (GM2 REV)
Output destination of the sound that has been
processed by the chorus
MAIN
Chorus Output
REV
14
M+R
Chorus Level 0–127
15 Reverb Level 0–127
Explanation
Reverb will not be used
Basic reverb
Reverb that simulates the reverbera-
tion of a room
Reverb that simulates the reverbera-
tion of a hall
Simulation of a plate echo (a reverb
device that uses a metal plate)
GM2 reverb
Output in stereo to the OUTPUT jacks
Output in mono to reverb
Output in stereo to the OUTPUT jacks
and in mono to the reverb
Volume of the sound that has been
processed by the chorus
Volume of the sound that has been
processed by the reverb
45