Turning The Power On - Roland JUNO-Gi Owner's Manual

Turning the Power On

* Once the connections have been completed (p. 12), turn on power to
your various devices in the order specified. By turning on devices
in the wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
1. Minimize the volume of the JUNO-Gi and your speakers.
2. On the JUNO-Gi's rear panel, turn the [POWER] switch ON.
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down, you
may still hear some sound when the power is switched on, but this is
normal, and does not indicate a malfunction.
3. Turn on the power of your speakers.
4. Use the [VOLUME] knob to adjust the volume appropriately.
If you don't want the power to turn off automatically, turn off the "Auto Power Off" setting
The JUNO-Gi will automatically turn off when no operation has been performed for a certain length of time. (With the factory settings, the power
will turn off after 240 minutes.)
NOTE
When the power turns off, any unsaved modifications that you've made in the settings will be lost. If you want to keep the setting changes
you've made, make sure to save them beforehand.
If you want to leave the power on at all times, turn off the "Auto Power Off" setting as described below.
1. Press the [MENU] button.
2. Use the VALUE dial or the cursor buttons to select "4. System," and then press the [ENTER] button.
3. Press the [1] (GENERAL) button.
4. Use the cursor buttons to select "Auto Power Off."
5. Use the VALUE dial to change the setting to the "OFF" setting.
6. Press the [6] (WRITE) button to save the setting.
16
Turning the Power Off
1. Minimize the volume of the JUNO-Gi and your speakers.
2. Turn off the power of your speakers.
3. Turn the JUNO-Gi's [POWER] switch OFF.