Compressor; Enhancer; Limiter - Roland JUNO-Gi Owner's Manual

COMPRESSOR

Parameter Value
On/Off OFF, ON
Sustain 0–100
Attack 0–100
Level 0–100
116
Explanation
This parameter turns the compressor effect
on/off.
This sets the sustain for the sound.
This sets the attack (onset) of the sound.
This sets the volume level of the effect.

ENHANCER

Parameter Value
On/Off OFF, ON
Sens
0–100
Freq
1.0–10.0 (kHz)
Mix Level 0–100
Low Mix Level 0–100
Level 0–100

LIMITER

Parameter Value
On/Off
OFF, ON
Threshold -24–0dB
Attack 0–100ms
Release 50–5000ms
Explanation
This parameter turns the enhancer effect
on/off.
Adjusts the manner in which the enhancer
will be applied relative to the input signals.
Adjusts the frequency at which the
enhancer effect will begin to be applied.
The effect will be made apparent in the
frequencies above the frequency set here.
Adjusts the amount of phase-shifted sound
of the range set by "Frequency" that is to
be mixed with the input.
Adjusts the amount of phase-shifted sound
of the lower range that is to be mixed with
the input. The frequency range in which
the effect is applied is fixed.
Adjusts the volume of the enhanced
sound.
Explanation
Sets the limiter to ON or OFF.
Adjust this parameter to match the signal.
Limiting will be applied to input levels in
excess of this level.
This sets the time it takes for the limiter to
go into effect once the input level exceeds
the threshold level.
Adjusts the time until when the limiter will
turn off after the input level falls below the
threshold level.