Table of Contents
Advertisement
User Manual 3155
INSTrument:COUPle:PHASe<phase>
Purpose
This command programs the phase offset between the master and slave units. This command has no effect
on the instrument in modes other than instrument couple.
•
<phase> sets the leading edge offset between master and slave units
Parameter type
Numeric (integer only)
Parameter range
<phase>
0 to "n" in units of waveform points, where "n" is the size of the active segment. The phase
offset can be programmed in increments of 4 points.
INSTrument:COUPle:PHASe?
Response to query version
The 3155 returns the present phase offset value. Default value is 0.
INSTrument:SET {0|1|2}
Purpose
This command prepares the master and slave units for multi-instrument synchronization. A procedure for
synchronizing multiple instruments is given below.
Parameter type
Numeric (integer only)
Programming Reference 4-49
Advertisement
Table of Contents
