Racal Instruments 3155 User Manual page 137

User Manual 3155
APPLy:RAMP{<freq>,<ampl>,<offs>,<delay>,<rise>,<fall>}
Purpose
This command is a high-level command that programs the 3155 to output ramp waveform along with its as-
sociated parameters
•
<freq> sets the output frequency in units of Hertz
•
<ampl> sets the output amplitude in units of Volts
•
<offs> sets the output offset in units of Volts
•
<delay> sets the delay to the pulse rise transition in units of %
•
<rise> sets the pulse rise time in units of %
•
<fall> sets the pulse fall time in units of %
Parameter type
Numeric
Parameter range
<freq> 100e-6 to 50e6
<ampl> 80e-3 to 8
<offs> -3.6 to +3.6
<delay> 0 to 99.9
<rise> 0 to 99.9
<fall> 0 to 99.9
APPLy:RAMP?
Response
The 3155 returns <freq>, <ampl>,<offs>,<delay>,<high>,<fall>. Default values are
APPLy:SINC{<freq>,<ampl>,<offs>,<N_cycles>}
Purpose
This command is a high-level command that programs the 3155 to output sinc waveform along with its asso-
ciated parameters
•
<freq> sets the output frequency in units of Hertz
•
<ampl> sets the output amplitude in units of Volts
•
<offs> sets the output offset in units of Volts
•
<N_cycles> sets the number of zero crossing
Parameter type
Numeric
Parameter range
<freq> 100e-6 to 50e6
<ampl> 80e-3 to 8
<offs> -3.6 to +3.6
<N_cycle> 4 to 100
APPLy:SINC?
Response
The 3155 returns <freq>, <ampl>,<offs>,<N_cycle>. Default values are
1e6,5,0,10,10,10
1e6,5,0,10
Programming Reference 4-27