Avaya C360 Installation And Configuration Manual page 31

Figure 6: Order of Function 'Parameters Selected with the Left/Right Front Panel Buttons
Figure notes:
1. PoE LED on C360-PWR only
Table 3: C360 Function LED Descriptions 1 of 3
LED Description
Name
PWR Power Status
SYS System Status
ROUT Routing Mode
Starting Point
(after Power-up or Reset)
Left Right
Button Button
LNK
1
PoE COL
LAG
Hspd
Rx
FDX
LED Status
OFF - Power is off
ON - Power is on
Blinking - Main power is down and BUPS is
active
OFF - Module is a slave in a stack
ON - Module is the stack master, and the optional
Octaplane and Redundant cable(s) are either not
connected or not active.
This LED will also light in Standalone mode.
Blinking - Switch is the stack master and the
Octaplane is in redundant cable is active.
OFF - Layer 2 mode
ON - Router mode
C360 Front Panels
Tx
Issue 1 July 2006
1 of 3
31